A typical EV enquiry names a motor power, a battery capacity and a controller, and asks for pricing. It can be quoted, and the quotation is usually not useful — because those three numbers were chosen independently, and in an electric powertrain they are not independent. Voltage, power, capacity, gearing and thermal strategy constrain each other. Fix them one at a time and the result is a vehicle that meets none of its targets while being more expensive than one that does.
The duty cycle is the specification
What the vehicle does all day determines every component choice downstream. Not the peak figures — the repeated, ordinary working pattern:
- Kerb weight and payload, and how often it runs loaded versus empty
- Daily distance, and whether it is one continuous run or many short trips
- Speed profile, and how much of the day is spent stopped
- Gradients, and whether they are met loaded
- Stop-start frequency, which drives thermal load more than top speed does
- Ambient temperature range, and whether the vehicle sits in the sun between runs
- Charging opportunity — overnight only, or a depot break in the middle of the day
A three-wheeler doing 120 km of urban stop-start work fully loaded and a three-wheeler doing 120 km of steady suburban running lightly loaded need different motors, different cooling and different battery sizing, even though the range figure is identical.
Then voltage, and it decides more than you expect
System voltage sets current for a given power, and current sets conductor sizing, connector selection, contactor ratings, losses and heat. It also constrains which motors, controllers and chargers are available to you at sensible cost. Choosing voltage late means re-selecting components that were already chosen; choosing it early, from the power the duty cycle demands, means the rest of the selection converges instead of oscillating.
Continuous power, not peak power
Peak power sells motors and continuous power moves vehicles. What matters is the power the motor can hold at the temperature it will actually reach in your duty cycle, with your cooling, in your ambient. A motor rated generously on paper and thermally derated in service is the most common disappointment in this category, and it is entirely predictable from the duty cycle.
Gradeability is the honest test. State the gradient, the load and how long the climb lasts, and the required continuous rating falls out of it.
Battery: capacity, chemistry and format together
Capacity comes from daily energy consumption plus a margin for degradation, temperature and the reserve the operator will actually keep. Chemistry is a trade between energy density, cycle life, thermal behaviour, cost and safety — and the right answer differs sharply between a light two-wheeler and a depot-charged commercial vehicle. Pack format and mounting then have to survive the vehicle's real vibration and ingress environment, which for many markets is more demanding than the datasheet assumes.
The BMS is part of this decision, not an accessory to it. Its protection thresholds, balancing behaviour and communication interface have to match the pack, the charger and the vehicle controller.
Charging is an operational choice
AC or DC, at what power, and against what turnaround requirement. Fast charging raises thermal load, affects cycle life and requires infrastructure the operator may not have. Depot overnight charging is usually cheaper in every dimension. Decide this from the operating pattern rather than from a specification-sheet ambition, because it feeds back into the battery and cooling decisions.
Thermal strategy ties it together
Air or liquid cooling for the motor, the controller and the pack. Air is simpler and cheaper and sufficient for many light-vehicle duty cycles. Liquid becomes necessary as continuous power, ambient temperature and charge rate rise. This choice is often left to last and it is often the reason a programme has to re-select components, because a system that cannot hold its temperature cannot hold its rating.
Programmes that arrive with a duty cycle and open questions get further, faster, than programmes that arrive with a fixed parts list and a fixed budget. The parts list is the output of this conversation, not the input to it.




